Jun
28
trash2cash asked:
I found a Craftsman lawnmower in the trash that leaked gas. I replaced the carburator needle, and seat. It says to use a number 4 drill bit to adjust the float, but i could never find this particular drill bit in the store. Is their an alternative drill bit i could use instead, or is their another way?
Craig
I found a Craftsman lawnmower in the trash that leaked gas. I replaced the carburator needle, and seat. It says to use a number 4 drill bit to adjust the float, but i could never find this particular drill bit in the store. Is their an alternative drill bit i could use instead, or is their another way?
Craig
Comments
No Responses to “Tecumseh Carburator Float Level On Craftsman Lawnmower?”
level at full point. even distance to the top of bowl along top of float
0.209 inches and 5.309mm are the respective sizes for a number 4 drill bit. That is extremely close to the same size as number 4 copper wire. I guess you can go the hardware store with this information, but I think I’d check first with a small engine repair shop and see what they say..